How do you install your Bikefinder in the handlebar?


1. You start by unpacking your Bikefinder box, and take out the Bikefinder itself.


2. You put it inside the handlebar. If the handlebar is big inside, and it seems a little loose, you can put the blue part inside of the Bikefinder box aorund the Bikefinder to make it tighter.


3. Make sure to fit it so there is no room between the handlebar and the black end of the Bikefinder. The picture below indicates how it should look like. 

Do also install it so that the arrow is poiting up.


4. After putting it inside the handlebar facing the right way, you tighten the screws. The screws are to be tighten so hard that you are unable to drag it out and, it is hard to twist the screwdriver when rotating.

The pictures under shows how the screws, the srewdriver and how the installations should look like in the end.


A dummy bar-end can be bought seperately through our webstore to make the handlebar identical on each side. The dummy bar-end is installed the same way as the Bikefinder.


You can buy the dummy bar-end here:

https://bikefinder.com/ekstradeler/


If you have any questions - contact us here